PGTIC2 is an interior corner pipe grip tie.
Material:12 gauge
Finish: ZMAX®
Installation:
•Use all specified fasteners; see General Notes.•PGTIC2Z-R to Post — Install two set screws (supplied) with 3⁄8 socket in predrilled holes.
•PGTIC2Z-R to Rails — Use 1⁄4" x 1 1/2" Strong-Drive® SDS Heavy-Duty Connector screws (not supplied).
•Install on vertical pipes, offsetting corners to allow for the correct rail alignment.
•Fasten PGT with 1⁄4" hex head bolt (supplied).
•1⁄4" lag screws may be used. Follow the code requirements for predrilling.
•Nail or screw fence boards to rails.
•Field bend PGT flanges to fit corner and angled conditions (bend one time only).
•Fasten to rails using 1⁄4" Strong-Drive SDS Heavy-Duty Connector screws or 1⁄4" lag screws (follow code requirements for predrilling).
